techmob
Regular Member
- Joined
- Mar 26, 2006
- Messages
- 102
- Reaction score
- 0
- Points
- 0
- Age
- 44
- My Satellite Setup
- 80 cm dish, superjack dg120, technomate 1500ci+
- My Location
- north wales
Hi all, currently have a dm500 downstairs and arriving tomorrow will be my new technomate 9100 this will be going in my bedroom.
I want both box's to be able to control the motor, so i have decided to go with a HIGH ISOLATION AB SWITCH
I have a concern regarding the switch, because when i set my dads technomate 1500 with a superjack dg120 motor, the cable had a join in it , we had a good signal but the motor would not respond at all
It turned out to be the join in the cable, even though it gave a good signal the break in the connection where the join was must of been enough for the pulse of the motor to lose itself at this point (maybe i am talking rubbish)
After replacing the cable with a complete line with no join in it, the motor worked perfectly
My concern is that now i will be having two receivers being channeled through this switch, there is obviously a break where it connects inside the switch and from there the single cable going to the motor
Am i likely to experience a similar problem as my dads setup when he had a break in his cable?
Are there any other problems i may come across in your experience?
thanks for reading and hope someone can clear my mind
:-worship
I want both box's to be able to control the motor, so i have decided to go with a HIGH ISOLATION AB SWITCH
I have a concern regarding the switch, because when i set my dads technomate 1500 with a superjack dg120 motor, the cable had a join in it , we had a good signal but the motor would not respond at all
It turned out to be the join in the cable, even though it gave a good signal the break in the connection where the join was must of been enough for the pulse of the motor to lose itself at this point (maybe i am talking rubbish)
After replacing the cable with a complete line with no join in it, the motor worked perfectly
My concern is that now i will be having two receivers being channeled through this switch, there is obviously a break where it connects inside the switch and from there the single cable going to the motor
Am i likely to experience a similar problem as my dads setup when he had a break in his cable?
Are there any other problems i may come across in your experience?
thanks for reading and hope someone can clear my mind
:-worship