'update message' and 'out of order'?help

G

gailr2209

Guest
Can anyone help? tried to update /add channels and now box is not working at all?
 

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,292
Reaction score
1,615
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
[updated:LAST EDITED ON 20-Feb-02 AT 07:05 PM (GMT)]What is it actually doing, is it stuck in standby?

Just seen your other post, and it would appear that you are getting error messages. As a first resort you could try pulling out the plug and reconnecting the power. Second try a factory reset see this thread http://www.satellites.co.uk/scripts/webforum/DCForumID24/451.html.

Lastly if none of the above work, then there is a small hole next to the card slot into which you insert a small scredriver or plastic needle to force a reset.
Rolf
 
G

gailr2209

Guest
not sure its my brothers box,he phoned and asked if I could help.
He tried to add channels which he thought worked,then later all channels went off and he gets 'update error' messages and 'out of order messages' on the front led display.So I think it must be stuck in standby.
 
Top