which colour wire goes where on motor

[<sammy>]

my setup: echostar D2510ip viaccess receiver
1 meter solid dish
silent gold 99 motor

I just purchased a JAEGER SILENT GOLD 99G H to H 36 VOLT mount.
Can anyone tell me which colour wire goes where,on motor & receiver.
{reed sensor type}....motor.. as it says you can blow the sensor if wired wrong.

i have 4 wires:
red - thick
green - thick
black - thin
white - thin

1 -
sensor
2 -
MOTOR (REED SENSOR TYPE)
3 -
motor
4 -



M1 M2 MPULSE
- - -
BACK OF RECEIVER
- - -
+5V GND SKEW


I'm going to try and install it this weekend, as i can`t find a installer
in my area... only sky..
many thanks <sammy>.

 

[Llew]

my setup: echostar D2510ip viaccess receiver
1 meter solid dish
silent gold 99 motor

I just purchased a JAEGER SILENT GOLD 99G H to H 36 VOLT mount.
Can anyone tell me which colour wire goes where,on motor & receiver.
{reed sensor type}....motor.. as it says you can blow the sensor if wired wrong.

i have 4 wires:
red - thick
green - thick
black - thin
white - thin

1 -
sensor
2 -
MOTOR (REED SENSOR TYPE)
3 -
motor
4 -



M1 M2 MPULSE
- - -
BACK OF RECEIVER
- - -
+5V GND SKEW


I'm going to try and install it this weekend, as i can`t find a installer
in my area... only sky..
many thanks <sammy>.

Hi sammy
The thick wires (red and green) will be for the motor, and will go to the Echostar's M1 and M2 terminals. Switch these terminals if the motor goes in the wrong direction.
The thin (sensor) wires go to MPULSE (white) and GND (black).

Llew

 

[Llew]

I might add that there's no hard and fast rule regarding the sense of the M1/M2 connections - it depends on the particular motor/receiver combination. If someone has the same setup as you, they may be able to tell you the exact connection.

Llew

 

[<sammy>]

Thanks for the replies llew..
i`ll give it a try..
sammy.