Hi all
God my head is done in so I hope someone can help
Until a few weeks ago I was able to get Multivison channels on my Humax 5400 using my 6 in 1 Funcard.
My dish started playing up but is ok now (free hotbird channels are fine)
However It appears the codes have changed during the 6 or so...
I did see the file on RDI-SAT but still no joy.
My questions is: is there a standard hex file out there that I can program my 6 in 1 card to work on my Humax 5400 or do I need to do something else too.
Thanks
Until recently I was able to access TPS via my Fun 6 in 1 on my Humax 5400
Can I assume its a simple code change and I will just need to progam the new ones in.
If so where can I find the relevant file as I am having no luck
Cheers
Mick
I used to use my vxcardmaster to program my fun 6 in 1 card
My 6 in 1 card was recently 'urgraded' so it can get the multivision channels
When I try to load the mach1 files to update my card and program them in I get a message loader failed
Any ideas
Cheers
I believe that if you have a fun card you receive the multivision channels
Can anyone tell me if my VXtools programmer will enable me to do this and if so what files I will need
Cheers
I have been unable to access anything on Hotbird via my motorised disk
The signal level is 'okish' at 34% but I get 0% signal quality
The signal quality on my other sat's (Astra, Sirius etc is fine)
What is the most likely cause of my problem
Cheers
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.