I will try to monitor the output signal by tapping it from the coax line to the motor when in motion by an oscilloscope to see if there is any problems with the 18V (H) when the motor is moving.
Hello,
Got the Relook box before 45 min ago, tested to zap between sattelites with USALS configuration and H channels, works 100%! also, the movment is little bit faster (better tuner in the relook 400).
so the problem can be the tuner in the DM800 or the software or the DM800 mainboard. When...
Hello,
Thanks for your input, the motor is brand new and was changed because the old one stops to move completely. I will try to borrow another satbox to try the motor, I will get access to a relook box tomorrow and try it out.
Just curious, is this a typical symtom of a faulty motor where it...
Thanks for the information, I measured the voltage, it was correct for V (about 13) and H (about 18), i suspect current sourcing from the DM800 Power Supply , I will try a 5A 12V supply.
Best regards,
Freiwat
Hello,
I have a problem moving the dish with the STAB 120 positioner from my DM800. ´
Is is like this:
Setup is in USALS mode, When I try to move to a different sattellite using a horizantal channe on that sattelitel, the dish most of the times fails to move or goes in the wrong direction or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.