Recent content by Jeff_Coke

  1. J

    Cam problems, Triple Dragon

    Hi there, Thank you Llew, solved the prolem, anyone else looking for the resistor, it's under the hard drive. Thanks again, Jeff.
  2. J

    Cam problems, Triple Dragon

    Hi there, I recently upgraded from a Matrix revolutions cam to a T-rex dragon cam, the problem is the Triple Dragon goes nuts after the cam is inserted, the screen flashes and tries to display something, can't quite read it as is flashes too fast, Llew said something about cutting a resistor in...
  3. J

    V-Box

    Hi there, I have bought and am using the V-box with my Digiquest 2000 on an old syle actuator arm positioned dish, I can comfirm the V-box converts DiSEqC 1.2 commands, the input to the V-box is the LNB cable, the output is the LNB cable, plus four sprung terminals these are the 36v control to...
  4. J

    Digiquest upgrade

    Hi there, The Digiquest P2000 software update is now available to download, the version is 30001, some of the changes:- 5000 channels as many satellites as you want improved installion menus this was downloaded on the 24/07/01 from Hotbird Regards, Jeff...
  5. J

    Site Censorship ?

    Hi, I have seen your replys You will have to do a hard reload (Shift reload (Netscape)) if you want to see them, your browser is probably reading the page from it`s cache, I had the same problem. Regards, Jeff...
  6. J

    viaccess fails, help please

    Hi. For information only, The receiver was at fault, Wizard have supplied me with a new Digiquest, with the updated version of software (2.0008) I have now successfully programmed a viaccess wafer with my VXmulti and all is working fine. Thanks for all your help. Regards, Jeff...
  7. J

    Embedded cam

    Hi there, Can somebody please tell me which are the best viaccess files to use in an embedded cam, the machine (in case it makes a differance) is an Digiquest P2000 Now running Version 2.0008 Many thanks Jeff...
  8. J

    Bad programming

    Thanks 2ol My Digiquest P2000 is back with the retailer at the moment, I wanted to be sure they could not say, "it`s your own fault inserting pirate cards" or such like. Regards Jeff...
  9. J

    Bad programming

    Hi Can a incorrectly programmed wafer card (i.e. wrong files or flashed in the wrong order) do any damage to the host machine?
  10. J

    viaccess fails, help please

    Hi there, Yes I have tryed those files will similar results, The receiver seems to have taken a turn for the worse, it now says both cards are in the machine even when they are not I have tryed rebooting and updating the version software but this is not helping, I have phoned the supplier and...
  11. J

    viaccess fails, help please

    I programmed both cards with the seca codes to try to prove out the embedded cam slots, the machine saw both cards. I am using flat gold cards nothing visable apart from the contacts. I also wondered about which way up so I had a look with a torch to confirm, P.S. sorry for posting to the wrong...
  12. J

    viaccess fails, help please

    Hi there, I am having problems with programming a viaccess wafer, I have a digiquest p2000 with two cams built in, I have already programmed a seca wafer which works fine, when I insert the programmed viaccess wafer the machine locks up, has anybody any ideas, I have tried all the codes I can...
Top