Recent content by jitc

Does anyone know of a support forum or drop off point for the TitaniumS2CardSoft v18n rev1 software? Stv

Successfully restored XCAM!! Just to finish the thread. I received my XCAM/Nextwave programmer interface this morning from CardWriterBV (excellent service....guys) 1. Insert XCAM into a CI slot. (I has to use the bottom slot on my Topfield box, top slot would not load the firmware at all)...

Thanks for your reply hjg, but I can't activate the CI menu on the STB, it has no menu, it just say's "XCAM Module". Both methods above, require this work. I'll order a UCAS/Nextwave programmer, as both repair methods, do require one and see how it goes. I reply on the post on my progress.....

I recently upgraded my XCAM to 1.05 succesfully from 1.04. After doing a recent Softkey update, i realised that the softkey file included some indents, that my Titanium card should be processing only. I then updated again to 1.05, but after reloading the cam interface, it returned to a virgin...

All Sorted, reset the box and then tried other slot, all worked fine.

I have tried it with a fun6,fun4,seca mosc and a tit card and it still states "No card found", that's why I'm really stumbled!

I just received a new xcam, with ver 1.04 loaded. When i look in my Receivers CI Menu for Xcam 1.04, the card info reports "no card inserted!" Is this correct? I'm trying to use a 6in1 to update the keys.. Any help would be appreciated!:confused:

Simple question, but can a X-Cam program a Titanium card ? Any ideas on a software solution?

The OnDig box requires the CAM software to be updated OTA before the Keys can be received and sent to the Card. To update the software; channel 17 between 12:00-00:50 channel 33 between 05:00-12:00 After the box has been updated the card should be inserted and the MK01, OPK's 0C, 0D and OE are...