Thanks Channel Hopper, yes sat-shop have these as blademedia noted, I might make them a best offer, just trying to decide if I want to attempt putting in a DVB-T tuner or just add two DVB-S.
Will setup a streaming with kodi to the kitchen soon so need more tuners...
EDIT: Hmm, they removed...
I want to add another couple tuners to my HD2400 box, but WOS seem to not list them anymore, googling around was a bit random as they seem to mostly only be available in Germany and some Netherland stores with big postage.
Anyone know where I can buy Mutant tuners in the UK?
CI+ CAM works out of the box with factory image so all good.
Loaded openATV now but some channels breaking up tonight which I am going to attribute to the weather not the image. Stuck with German webif so need to find where that language setting is...
Going to check/tweak dish alignment...
digi247 - thanks, I do understand the transcode, previously iPad would sometimes struggle on the WiFi with HD channels, and I wanted to use a spare Pi and the old TV in another room which is only 720P so transcoding would help the early model Pi with the streaming which will be over WiFi...
I think the only thing worrying me is the CI+ support, the CAM I have says CI+ on it, but it worked fine in the Duo which I understood did not have CI+ support. It seems the CI/CI+ support comes from the manufacturer driver level not from E2, so Xtrend does not work or is unstable (plus battery)...
@Manicscrewdriver is that still a thing? I remember that from years back, I didn't even consider that was a problem still! Xtrend is out anyway, I just discovered from more research that the skylink irdeto CAM is CI+ and Xtrend does not list CI+ support and German forums have a lot of complaints...
Thanks for reply, your confirming the conclusion I also reached - they both seem solid and well supported.
The prices seem comparable with more than 2 tuners, the main requirement is it needs to work with a genuine subscription card/CAM but both have CI slots and the Duo worked, although only...
Hi All,
Vu Duo Plus died with the red light of death, I changed the cap and the burnt out regulator but still no-go, I think I damaged a track on the PCB when I did the regulator so I need to find a local repair place at some stage to see if it can be saved.
Given the ~3yr life for £300+...
If it helps mine sometimes throws a wobbly like that, but usually recovers without power startup or with power - suspect related to low voltage from battery pack somehow.
Thanks Capn. To answer my own question though as I made a breakthrough!:
DB9 - Signal - 3.5mm
Pin 2 RX - TIP
Pin 3 TX - Ring
Pin 5 - Ground - Surround/Ground
Turns out the other leads I had (I think from a NetApp disk array) were wired the opposite way round, with TX on the...
So... its a 9pin serial to a 3.5mm stereo jack, but I can't find the cable, or rather I can find 3 cables of this type but some are for disk arrays and I am not sure which is which!
Can anyone tell me assuming shield is ground which out of pin/ring is TX or RX? If you have a cable multimeter...
The ICE card is the one I have, I was advised by our Czech friends the Irdeto only cards do not work in softcam with Engima receivers (although I am using hardware CAM at the moment).
I *think* the latest skylink cards are both spec? I know they were moving over from the encryption standard, and I was advised to get the card support both old and and new for best compatibility.
The fortec start are not great, someone I knew bought one then quickly changed (he was trying to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.