The dish could be out but it is the best it has been so far, thanks to the calm day. I can get transponders on 28.2E and 30W. I have not been any further.
I used usals to move to 5w before I aligned the dish. I used my exact long and lat. I dont think the motor moved much, as you would expect...
I have noticed this myself. I finally had a dry, wind free day to setup. When I enter my lat and long (I used them to point the dish at 5W to setup, although I dont know if that was a mistake) all my sats are slighly west of the position. How much did you find you had to adjust by?
Pete
I ended up putting tape on them. 4 lnbs, 2 connectors into each. They then went into 2 4x switches, which I taped as well. Not to mention the motor connections etc. I also put all the plugs on too. Took ages, lol.
My install is going well. I am just running on one lnb just now, the one most in...
Hi,
I was wondering about USALS on the 7025. I see people have had problems getting it to work. If it is broken does it not work at all? Or does it just give the wrong postions.
I have been setting up my dish but I have not had much luck so far. Although the weather has been horrific/I am new...
The wind was really bad I have to say, I guess a night and day of it was just too much for them to take. I think if they had been tighten properly they would have been ok.
I had the same problem when I was adjusting the dish as well. Although I was doing it in the wind and rain, lol.
Pete
I am the top of a 5 story block of flats. It is like win tunnel sometimes. I have to say these are the worst winds I have seen in years.
On a happier note I did realise that the lnb arm goes through the dish, so even if all the bolts came out it should not fall, lol. I will have to see what I...
Well it has only been up one day and it almost blew away. Not a good start really. It is a triax 1.1m dish. It is blowing a gale here in scotland and somehow the vibration worked 3 of the blots loose that hold the dish surface to the bracket behind. I got the dish second hand it was already...
The lnb's I have have a plug down plastic part that covers the connections. I would still put tape on them, but I wondered is this really necessary?
Thanks.
Pete
Hi,
Well I have just taken delivery of my DM7025 and having lots of fun figuring it all out.
The previous owner told me that he has 3 months left of what I assume is a cardshare subcription (I am new to all this). I glanced over the settings and I see there is a server in the list.
All I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.