Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Gibertini 125 installation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tururu" data-source="post: 872010" data-attributes="member: 227656"><p>First , excuse the translations .This is the OP130 model, not sold, but has almost the same measurements you want.Holm got to be more than 75cm from the roof or on the roof give the initial tube use was 60mm , the other longer , go to 75mm .</p><p>When the mountain to see action , install it on a stand 40mm I have for evidence and truth is a joke , remember that a 40mm tube with weight 18kgs is flexible, in days of wind will move much .In photo 3 you see a piece marked as OK ( in red) , it is essential that you stop at the end of the used tube , given the weight antenna slide down the tube if you do not have that piece, if long press on the screws so that not pass, the tube used or depart screws deform .</p><p>As commented this antenna no longer sold, the default is that it has the focus well designed and can move the LNB almost 10cm where it was installed without loss of signal, is facing Astra19Este to see some German satellites who asked 150cm antenna by Madrid, tuned to 100% could see the defect.It has a tad more gain than the 94cm antenna I have, but for a DreamBox7020 tuner ( deaf ) just enough to run in 2000-2005.</p><p>When you have set to 100% the antenna , check if remedy the defect that said, I always have the idea of turning it into Gregorian , but never encouraged me . tubo de 60cm de acero/fontaneria.</p><p>tubo de 60cm de acero/fontaneria. ">Buy a mast 40mm are normal, but is flexible to the weight , if you do not find wider == > 60cm steel pipe / plumbing .</p><p>Do not forget modifficar support, a good base of concrete separated more than 50cm from the wall, a tube of 60/75mm is not a bad idea/solution.</p><p>You can not get water to the tube / holder, sealed with foam insulation or in this case having drain.</p><p></p><p>Remember the earth.</p><p>-----------------</p><p>Lo primero, disculpa la traduccion.</p><p>Este es el modelo OP130, ya no se vende, pero tiene casi las mismas medidas de la que quieres.</p><p>Tiene que estar por encina del tejado mas de 75cm o dara en el tejado, el tubo inicial que use fue de 60mm, por otro mas largo, pase a 75mm.</p><p>Cuando la monte para ver medidas, la instale en un soporte de 40mm que tengo para pruebas y la verdad, queda como un chiste, recuerda que un tubo de 40mm con los 18kgs de peso es flexible, en dias de viento se movera mucho.</p><p>En la foto 3 ves una pieza marcada como OK (en rojo), es fundamental que realice tope en el final del tubo usado, dado el peso la antena se deslizara por el tubo si no tiene esa pieza, si aprietas mucho los tornillos para que no pase, se deformara el tubo usado o partiran los tornillos.</p><p>Como comento esta antena ya no la venden, el defecto es que no tiene el punto focal bien diseñado y puedes mover el LNB casi 10cm de donde esta instalado sin perdida de señal, esta orientada al Astra19Este para ver unos satelites alemanes que pedian 150cm de antena por Madrid, afinada al 100% se podia ver el defecto.</p><p>Tiene un pelin mas de ganancia que la antena de 94cm que tengo, pero para un sintonizador DreamBox7020 (son sordos) lo justo para funcionar en 2000-2005.</p><p>Cuando tengas ajustada al 100% la antena, revisa si solucionaron el defecto que comento, siempre tengo la idea de convertirla en Gregoriana, pero nunca me animo.</p><p>Compra un mastil de 40mm son normales, pero es flexible al peso, si no lo encuentras mas ancho ==> tubo de 60cm de acero/fontaneria.</p><p>No olvides modifficar el soporte, una buena peana de hormigon separado mas de 50cm de la pared, con un tubo de 60/75mm no es mala idea/solucion.</p><p>No puede entrar agua al tubo/soporte, sellar con espuma de aislamiento o en este caso que tenga desague.</p><p>Recuerda la toma de tierra.</p></blockquote><p></p>
[QUOTE="Tururu, post: 872010, member: 227656"] First , excuse the translations .This is the OP130 model, not sold, but has almost the same measurements you want.Holm got to be more than 75cm from the roof or on the roof give the initial tube use was 60mm , the other longer , go to 75mm . When the mountain to see action , install it on a stand 40mm I have for evidence and truth is a joke , remember that a 40mm tube with weight 18kgs is flexible, in days of wind will move much .In photo 3 you see a piece marked as OK ( in red) , it is essential that you stop at the end of the used tube , given the weight antenna slide down the tube if you do not have that piece, if long press on the screws so that not pass, the tube used or depart screws deform . As commented this antenna no longer sold, the default is that it has the focus well designed and can move the LNB almost 10cm where it was installed without loss of signal, is facing Astra19Este to see some German satellites who asked 150cm antenna by Madrid, tuned to 100% could see the defect.It has a tad more gain than the 94cm antenna I have, but for a DreamBox7020 tuner ( deaf ) just enough to run in 2000-2005. When you have set to 100% the antenna , check if remedy the defect that said, I always have the idea of turning it into Gregorian , but never encouraged me . tubo de 60cm de acero/fontaneria. tubo de 60cm de acero/fontaneria. ">Buy a mast 40mm are normal, but is flexible to the weight , if you do not find wider == > 60cm steel pipe / plumbing . Do not forget modifficar support, a good base of concrete separated more than 50cm from the wall, a tube of 60/75mm is not a bad idea/solution. You can not get water to the tube / holder, sealed with foam insulation or in this case having drain. Remember the earth. ----------------- Lo primero, disculpa la traduccion. Este es el modelo OP130, ya no se vende, pero tiene casi las mismas medidas de la que quieres. Tiene que estar por encina del tejado mas de 75cm o dara en el tejado, el tubo inicial que use fue de 60mm, por otro mas largo, pase a 75mm. Cuando la monte para ver medidas, la instale en un soporte de 40mm que tengo para pruebas y la verdad, queda como un chiste, recuerda que un tubo de 40mm con los 18kgs de peso es flexible, en dias de viento se movera mucho. En la foto 3 ves una pieza marcada como OK (en rojo), es fundamental que realice tope en el final del tubo usado, dado el peso la antena se deslizara por el tubo si no tiene esa pieza, si aprietas mucho los tornillos para que no pase, se deformara el tubo usado o partiran los tornillos. Como comento esta antena ya no la venden, el defecto es que no tiene el punto focal bien diseñado y puedes mover el LNB casi 10cm de donde esta instalado sin perdida de señal, esta orientada al Astra19Este para ver unos satelites alemanes que pedian 150cm de antena por Madrid, afinada al 100% se podia ver el defecto. Tiene un pelin mas de ganancia que la antena de 94cm que tengo, pero para un sintonizador DreamBox7020 (son sordos) lo justo para funcionar en 2000-2005. Cuando tengas ajustada al 100% la antena, revisa si solucionaron el defecto que comento, siempre tengo la idea de convertirla en Gregoriana, pero nunca me animo. Compra un mastil de 40mm son normales, pero es flexible al peso, si no lo encuentras mas ancho ==> tubo de 60cm de acero/fontaneria. No olvides modifficar el soporte, una buena peana de hormigon separado mas de 50cm de la pared, con un tubo de 60/75mm no es mala idea/solucion. No puede entrar agua al tubo/soporte, sellar con espuma de aislamiento o en este caso que tenga desague. Recuerda la toma de tierra. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Gibertini 125 installation
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top