dids858
Member
- Joined
- May 26, 2009
- Messages
- 28
- Reaction score
- 0
- Points
- 0
- Age
- 47
- My Satellite Setup
- 80cm motorised dish with Icecrypt 1.2
- My Location
- UK - Yorks
I've got my icecrypt motorised set up, up and running but I keep having an issue where it sticks on one sat and refuses to move.
If I take the cable from the LNB to motor out it will move around happy. So I have checked this cable and made sure it was all correct. (Getting good quality signal).
Still it was doing it. So I then changed the cable from the LNB to the motor and it was working great yesterday. Moving fine from 12.5w to 28.2E but then last night it was stuck again. However I did check this morning and the dish in the end did move from 19.2e to 1w. I left the STB (SL65 using Disqec 1.2) in moving mode.
So does anyone else have any ideas why this is or how to fix it.
I’m using a 80cm dish
Thanks all
If I take the cable from the LNB to motor out it will move around happy. So I have checked this cable and made sure it was all correct. (Getting good quality signal).
Still it was doing it. So I then changed the cable from the LNB to the motor and it was working great yesterday. Moving fine from 12.5w to 28.2E but then last night it was stuck again. However I did check this morning and the dish in the end did move from 19.2e to 1w. I left the STB (SL65 using Disqec 1.2) in moving mode.
So does anyone else have any ideas why this is or how to fix it.
I’m using a 80cm dish
Thanks all