tirosh
Regular Member
- Joined
- Jan 1, 2000
- Messages
- 312
- Reaction score
- 0
- Points
- 0
- My Satellite Setup
-
Echostar AD3600IPVA
Channel Master 1.2M
VxMulti, MM1.04
- My Location
- Essex
Guys,
I have a bit of a strange problem which I have not been able to solve and I wonder if anyone has come aross it before and can point me in he right direction.
Until 2 weeks ago my brother had a single TM-5500 receiver motorised with a CM1.2M dish and everything was working fine. Since then we have updated his system as follows:
- Receiver1 is a TM-5200. This is connected to a VBOX and then to the input of a Technomate Twin LNB
- Receiver2 is an older model TM-5500 (which was the main receiver until 2 weeks ago). This is connected to the other input of the twin LNB
If receiver1 is powered on then receiver 2 works perfectly. Even after powering down receiver1 receiver2 carries on working (as long as it's not powered off).
If however receiver1 is powered off then receiver2 gets "no signal".
I have checked the LNB Power and it is set to "on"
I have swapped the two receivers around and the behaviour is the same.
Does anyone know what could be wrong or what else I could check? Any help would be greatly appreciated.
I have a bit of a strange problem which I have not been able to solve and I wonder if anyone has come aross it before and can point me in he right direction.
Until 2 weeks ago my brother had a single TM-5500 receiver motorised with a CM1.2M dish and everything was working fine. Since then we have updated his system as follows:
- Receiver1 is a TM-5200. This is connected to a VBOX and then to the input of a Technomate Twin LNB
- Receiver2 is an older model TM-5500 (which was the main receiver until 2 weeks ago). This is connected to the other input of the twin LNB
If receiver1 is powered on then receiver 2 works perfectly. Even after powering down receiver1 receiver2 carries on working (as long as it's not powered off).
If however receiver1 is powered off then receiver2 gets "no signal".
I have checked the LNB Power and it is set to "on"
I have swapped the two receivers around and the behaviour is the same.
Does anyone know what could be wrong or what else I could check? Any help would be greatly appreciated.