Chris91
Member
- Joined
- Jul 17, 2019
- Messages
- 14
- Reaction score
- 1
- Points
- 3
- Age
- 33
- My Satellite Setup
-
-80 cm mesh Technomate
-Technomate TM-4
-Technomate 2600
-TBS 6908
-Sky mini dish
- My Location
- Midlands
Hello. I have a motor. Its a Technomate one... but it looks like they are all more or less the same units with different logos printed on them?
Anyway, I was wondering if it matters where 0 is programmed on the motor?
If I set 0 to be where the cast markings on the motor says its 20.0E, will that cause issues? Other than limiting east travel by the 20 degrees I just used up?
What I am trying to understand is, does it matter if I don't get the motor absolutely perfectly in the middle when I zero it?
Chris
Anyway, I was wondering if it matters where 0 is programmed on the motor?
If I set 0 to be where the cast markings on the motor says its 20.0E, will that cause issues? Other than limiting east travel by the 20 degrees I just used up?
What I am trying to understand is, does it matter if I don't get the motor absolutely perfectly in the middle when I zero it?
Chris