1M Gibertini Motorised

shamone

shamone

Regular Member
My Satellite Setup
Vu + Solo 4K, Viark SAT (4K), Mut@nt HD51
1.4M Famaval Dish, Technomate TM-2600 Super,
Inverto Black Ultra PLL 0.2dB Twin LNB, 53E - 30W + Gibertini 60cm 28E
My Location
N.E UK
Well after a long while I managed to get some pictures up of my install.

I still need to chop down the bolts on the back of the dish, when I get a new blade for the hacksaw.

You can see the use of some 'stones' to slightly push the pole a little more vertical on the one side. One day I may get around to sorting this properly, but until i pave over the bottom of the garden then I am going to leave it as is.
 

Attachments

  • 10072009118.webp
    10072009118.webp
    386.5 KB · Views: 429
  • 10072009116.webp
    10072009116.webp
    304 KB · Views: 400
  • 10072009117.webp
    10072009117.webp
    245.2 KB · Views: 398
  • 10072009120.webp
    10072009120.webp
    329 KB · Views: 385
Very nice - thankyou for posting those.

Just one suggestion, if I may be so bold?

Repeated back and forth movement of the dish across the arc will eventually cause the LNB to Motor cable to come loose at the Motor end F connector. The remedy is to use a slightly longer piece of cable and to secure said cable as close as you can to the Motor end using a cable tie to something that doesn't move eg Pole.

This means that the "pivot" for that cable is no longer the F connector.

Also, do check that neither cable gets snagged on clamp bolts etc. as the Dish approaches the ends of the arc (I note you're planning to cut the bolts down anyway).
 
Good Job Shamone!
 
very good install you have done there.

perhaps something to add to the pole to keep it level like a piece of metal bar that bolts to the fence post maybe to make it rigid ?
 
Due to the gale force winds a few weeks ago I had to redo my setup.

I came back from work and the dish which had been left at 13e was on more like 53e :eek:.

There was some play in the pole and the wind turned the dish around on the pole.


Removed the dish and pole and set to work on the hole again. This was no easy task as the old concrete was at the bottom of the hole and took some getting out.


1 bag of concrete mix 2 bags of sharp sand and 1/2 bag of pebbles made some mean motar for the hole. Also added some half bricks and rocks that were lying about the garden. Left all this to set for 2 days and then added 2 bags of post cement over the top for good measure.


Resulting in a pole that is 100% vertical with 0 play and a job that should have been done in the first place.:-DOH!


I have learned the hard way and should have done this on my first attempt.
 

Attachments

  • Picture2.webp
    Picture2.webp
    314.9 KB · Views: 181
  • Picture3.webp
    Picture3.webp
    463.6 KB · Views: 181
  • Picture4.webp
    Picture4.webp
    471 KB · Views: 166
Some sort of bracing might be a good idea also.
Nice job :)
 
Yes, nice work (In the end! - Mind you, I haven't exactly been immune to wind related failures over the years)

I agree with SM about bracing - that Pole is quite long and not only will the stresses where it enters the base be considerable, but the Dish end of things is likely to wave in the wind.
 
What receiver is that screengrab in post #1 from?
 
Thanks for the replys lads. I will sort some bracing to the fence post once I renew it as it is really weak and not well founded at the moment.


Both screens are from my TM500 with the UR image.
 
Hi Shamone,

Nice install.

I also have a 1m Gib and found that if you take the lnb to motor cable and pass it over the top then down between the motor body and mast mount then back up to the connection on the motor it makes for a neater job and may possibly keep the cable away from the extended dish bolts. Photos of my setup are also posted in this section if you want to have a look.

Out of interest, whereabouts in the NE? My mum lives in Langley Park!

Pete
 
Thanks Pete may alter the cable when I get my new LNB.


I live a fair bit away from Langley Park, down by the coast at North Shields
 
Well I have now installed my very expensive :cool: £13 dish in favor of the Gibertini.

I have not tweaked it much yet but is gives a slight signal increase on 4e and 26e.

When I get more time I will have more of a play with it to get the best from it.

I am going to brace the pole to the fence post once I get around to fixing the fence. Next doors tree is doing a nice job at the minute of keeping the fence up :)
 

Attachments

  • Picture 011.webp
    Picture 011.webp
    513.7 KB · Views: 136
  • Picture 013.webp
    Picture 013.webp
    803.3 KB · Views: 113
Looks good but I'd definitely see about some bracing for that pole now! Is the new dish steel? If so, you're going to have to watch out for backlash on the motor not only from the extra weight but the greater effects of wind forces. It certainly found some backlash on mine when I went up to a 1.2M, which is why I changed it for a Clarke Tech.
 
Good stuff!

Nothing to add about wind ............... s'obvious, innit?
 
What sort of signal do you get on 4.8e on the new one? I'm looking to upgrade to something a bit bigger and see if i can get a Viasat PL card, would be nice to know the results of someone local.

sonnetpete said:
Hi Shamone,

Nice install.

I also have a 1m Gib and found that if you take the lnb to motor cable and pass it over the top then down between the motor body and mast mount then back up to the connection on the motor it makes for a neater job and may possibly keep the cable away from the extended dish bolts. Photos of my setup are also posted in this section if you want to have a look.

Out of interest, whereabouts in the NE? My mum lives in Langley Park!

Pete
Click to expand...

Bit off topic I know but my mum is from Langley Park!, I'm originally from New Brancepeth too but currently go to uni at Newastle..
 
Can i ask you guys a question regarding performance of your the Gibertini? I have at the moment a Vu+ Duo connected up to a motorised 80cm Orbital with standard black inverto 0.2lnb just recently upgraded from dm600 and was hoping the better tuners in the Vu would save me having to upgrade my dish but still getting a fair bit of rain fade here in West Lothian. I was told that the 80cm Orbital would give a decent performance though i'm not so sure it's adequate now! Also heard the Inverto Black Ultra lnb might be a worthwhile upgrade! Pretty sure setup and allignment are good any thoughts?


[fieldset=Moderation]



I have deleted your duplicate Post[/fieldset]
 
The Gibertini will out perform any orbital dish. The Gibby coupled with a black ultra would make a nice system.
 
I am keeping an eye on this thread...I struggle with a Faro Penta 85cm on 4.8'E..I am condsidering trying a Gilbertini 1m and black ultra
 
Back
Top