Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Linux Based Receivers
Dreambox Support Forum
Dreambox Satellite Receiver | Tutorials | Software
Dreambox 500
Can I use DiSEQC switch and motor together on DB500?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="craignigel" data-source="post: 586103" data-attributes="member: 308395"><p>Hi again</p><p></p><p>Great, thanks I have done all that and I can switch between Hotbird and Astra without any problems (I get a brief message say dish is moving...but it isn't as its on Hotbird). I finely tweeked it using single east and west movements on the remote for highest quality and lowest error rate using BBC News. Then I stored it at Position 1. Correct??</p><p></p><p>Now do I add and store further sats on the arc (then I will know i was previously correctly aligned....wall bracket vertical etc)? GOTO xx is not ticked...i pressume that is right because I am going to add sats??</p><p></p><p>So lets say I'm going to add Astra1s at 19.2E. Could you just start me off please? Then I think I will be OK. I kinda understood what (and why) you were doing in the previous instructions.</p><p></p><p>Thanks so much and I hope this helps others in the future.:-worship</p><p></p><p></p><p>Regards</p><p></p><p>Bob</p></blockquote><p></p>
[QUOTE="craignigel, post: 586103, member: 308395"] Hi again Great, thanks I have done all that and I can switch between Hotbird and Astra without any problems (I get a brief message say dish is moving...but it isn't as its on Hotbird). I finely tweeked it using single east and west movements on the remote for highest quality and lowest error rate using BBC News. Then I stored it at Position 1. Correct?? Now do I add and store further sats on the arc (then I will know i was previously correctly aligned....wall bracket vertical etc)? GOTO xx is not ticked...i pressume that is right because I am going to add sats?? So lets say I'm going to add Astra1s at 19.2E. Could you just start me off please? Then I think I will be OK. I kinda understood what (and why) you were doing in the previous instructions. Thanks so much and I hope this helps others in the future.:-worship Regards Bob [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Linux Based Receivers
Dreambox Support Forum
Dreambox Satellite Receiver | Tutorials | Software
Dreambox 500
Can I use DiSEQC switch and motor together on DB500?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top