fibo 1.2 motor needed

G

garryh

Member
My Satellite Setup
1.2meter gregorian dish original 36v positioner motor
twin lnb
Tm 5500 cip plus
Tm9100
Humax hdci200
Silvercrest-SL65 E Dragon cam
Diablo cam
2xSS1 and SS2
V stream dvbt pci
Cas 3
My Location
Scotland
any one got a spare fibo 1.2 motor they would sell
 
I do have spare motors, which I may sell, PM me :)
 
Gerry

I have new and used in stock for you.
Also we can repair the broken one.

P.S we are not commurcial its hobby and we will not do this for busniss
Ron
 
thanks snuffer and johnsattuk for all you help
 
Please PM me, i can arrange new motors directly from Norway warehouse.
 
fitted the motor and all working well and super fast
also removed the tm 5500 cip and used gbox to control it
big differance to the old motor it was real slow
 
which motor / polar mount combination you got?
 
still using original set up for fibo only 5v mod for gbox
 
I will make a manual on my site for mod the box 5Volt.
 
It would be nice if you can post it here as well Ron. :)
 
garryh said:
still using original set up for fibo only 5v mod for gbox
Click to expand...

I thought garryh was using the reed sw. mod not the 5v gbox mod, perhaps he could clarify :)
 
No piont RolfW i place it here bud look to it and feel free to change the bad English of it.

Its realy simple.

Make a wire from J3 to a connector on the back this J3 next to the relay are the 5 V.
Look to R3 this can be remove and make a direct connection just over the Resistor so he is 0 Ohm normal 3300

Thats al i make Mon or theusday some foto's to show it.

Ron
 
took some photos of my dish setup
but dont know how to post them
 

Attachments

  • IMAG0029.webp
    IMAG0029.webp
    21.1 KB · Views: 56
  • IMAG0030.webp
    IMAG0030.webp
    53.2 KB · Views: 59
  • IMAG0027.webp
    IMAG0027.webp
    16.6 KB · Views: 72
No problem, Nice dish:-worship Its nice to see no stickers on the dish face. As mine has grundig logo on.

I did remove the Phillips logo from my 55cm Fibo, but it can still be seen.
 
Back
Top