hh90 problem

hope this is right


the plastic gears have lost teeth and the worm drive gears teeth are flattened off also the worm drive is very worn and hardly connects with the gear to drive the arm




[fieldset=Moderation] Uploaded picture as attachment - SM :)[/fieldset]
 

Attachments

  • 20090130_3.webp
    20090130_3.webp
    100.5 KB · Views: 32
dodgemaster said:
hope this is right


the plastic gears have lost teeth and the worm drive gears teeth are flattened off also the worm drive is very worn and hardly connects with the gear to drive the arm


Can you do a few shots.. main gear.. PCB etc.. (please..) and notice when you post that there is a paperclip option .. click on that to upload direct to here.. also you could put them on the motors section (see members pictures etc..).

Thanks ...
 
I will give it a go

have put pics in the motor internals comparison post
 
just found some paperwork the guy left with the sat system and the reciept says the motor is only 6 mnths old,
 
dodgemaster said:
just found some paperwork the guy left with the sat system and the reciept says the motor is only 6 mnths old,

Oh crikey!

My SG2100 has taken loads of hammer and has just had its fourth birthday.

If it failed now, I'd just shrug my shoulders.

(Plus I have a spare anyway ................. :-bunny)
 
dodgemaster said:
just found some paperwork the guy left with the sat system and the reciept says the motor is only 6 mnths old,

You should be able to get it replaced ....... an 85 shouldn't have a problem... we know of 1.1s on them and they just keep going... (you shouldn't really do that though:-rofl2)






hmmm.. something not right there...
 
pedro2000uk said:
You should be able to get it replaced ..
...

I doubt you'd be able to prove against excessive wear, lol.
 
getting replaced now the warranty seal has been trashed might prove a problem as well
 
:-rofl2 Good point. DiSEqC HH motors are fairly cheap enough now anyway, you might of just had a bad one :)
 
Back
Top