For programming the loader card:
You need to load the loader program onto your computer it is there in the dragon cam section in PREDATOR 0.4. Load also predator 10 file which is the latest to program loader card.
Once this is stored in your computer connect your programmer in 6.0 mhz phoneix mode and insert card. THIS IS VERY IMPORTANT that you first put your programmer in phoneix mode IF not auto detect will ruin your loader card. Open loader program and click on connect in the loader program. SEE YOU HAVE CORRECT COMPORT !
The program tells you if you are connected. Press program card and open file the latest one being predator 11 ( in dragon section)
The card will take 3 mins. to program. A programming progress bar is shown on the loader program.
Insert loaded card when done into the cam. REMOVE ALL CARDS, CAMS FROM YOUR RECEIVER AND then power off. Insert cam with card and be on a FTA channel, power on now, go to cam menu of your receiver. You will be asked if you want to update module say YES. In 3-4 mins your cam is programmed.Press refresh if if you want to see the programming percentage of your cam. When done it will tell you so ! Remove cam + loader card . Power off insert cam only without any card, power on and you are DONE ! You will now see predator10 in cam menu.