Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
I keep getting no signal for all the satellites and i'm going mad!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="mgyi99" data-source="post: 427263" data-attributes="member: 264796"><p>it could be possible that I didn't select the BBC World transponder properly, but I was a bit unsure of this in the first place. After doing 'GO TO REFERENCE', I highlighted THOR 0.8W and I chose 'Transponder' (yellow button) and the list of transponders appeared for THOR 0.8W. I selected the BBC World one and then went back to the menu, changed the LNB to Universal, changed the motor to Diseqc 1.2 and then tried scanning moving the motor a little bit right until a signal appears etc. I'm not sure if I did this the right way, I didn't see how else I could select the transponder, unless its TP Scan?</p><p></p><p>About my motor, its a Manhattan HH-100 or HH-120 as it says on the manual. I'm not sure if it supports USALS but I did try scanning a satellite with USALS and it found a few channels but I don't think it was the correct channels for that satellite.</p><p></p><p>thanks.</p></blockquote><p></p>
[QUOTE="mgyi99, post: 427263, member: 264796"] it could be possible that I didn't select the BBC World transponder properly, but I was a bit unsure of this in the first place. After doing 'GO TO REFERENCE', I highlighted THOR 0.8W and I chose 'Transponder' (yellow button) and the list of transponders appeared for THOR 0.8W. I selected the BBC World one and then went back to the menu, changed the LNB to Universal, changed the motor to Diseqc 1.2 and then tried scanning moving the motor a little bit right until a signal appears etc. I'm not sure if I did this the right way, I didn't see how else I could select the transponder, unless its TP Scan? About my motor, its a Manhattan HH-100 or HH-120 as it says on the manual. I'm not sure if it supports USALS but I did try scanning a satellite with USALS and it found a few channels but I don't think it was the correct channels for that satellite. thanks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
I keep getting no signal for all the satellites and i'm going mad!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top