Reply to thread

Message

<blockquote data-quote="ukmg" data-source="post: 543404" data-attributes="member: 296551">Thanks for the prompt reply.&nbsp; I'll try to respond to the points you raise as best I can (noob, so please bear with me!)I am using the embedded cam (emulator?) within the TM 5400.&nbsp; It's widely used and is recommended by the fairly well-known online retailer where I got the kit from.&nbsp; As I say, it works fine under &quot;normal&quot; use but my install/reinstall between &quot;official&quot; and &quot;unofficial&quot; software operating systems seems to cause the problem.In terms of what I've read, I recall a forum elsewhere where someone was getting a similar &quot;invalid smart card&quot; problem on DigitalAlb (if that's the correct channel name!?).&nbsp; The posts suggested that the broadcaster updated software/security(?) on a certain date every month, and he was to leave his box switched on (not off nor in stand by) on that channel so it could &quot;get&quot; the update.&nbsp; As a noob, I have no idea if that's correct, but it would seem a bit of a burden/not v efficient way to do things?Thanks again for taking the time to advise.UPDATE: PS I've tried the disconnect/full power off then on again, but with hitherto no joy...</blockquote>

[QUOTE="ukmg, post: 543404, member: 296551"] Thanks for the prompt reply. I'll try to respond to the points you raise as best I can (noob, so please bear with me!) I am using the embedded cam (emulator?) within the TM 5400. It's widely used and is recommended by the fairly well-known online retailer where I got the kit from. As I say, it works fine under "normal" use but my install/reinstall between "official" and "unofficial" software operating systems seems to cause the problem. In terms of what I've read, I recall a forum elsewhere where someone was getting a similar "invalid smart card" problem on DigitalAlb (if that's the correct channel name!?). The posts suggested that the broadcaster updated software/security(?) on a certain date every month, and he was to leave his box switched on (not off nor in stand by) on that channel so it could "get" the update. As a noob, I have no idea if that's correct, but it would seem a bit of a burden/not v efficient way to do things? Thanks again for taking the time to advise. UPDATE: PS I've tried the disconnect/full power off then on again, but with hitherto no joy... [/QUOTE]

Verification