Measurements of Feed Legs Channel Master 2.4 Antenna

[gatonico]

Hi to all i need if anyone may be to give me the measurements of the feed legs of one Channel Master 2.40 Antenna

i know that the material is 0.75 inch galvanized tube

Regards an thank you in advance

 

[sonnetpete]

Here's a link to a PDF file of the 2.4M manual.

_http://www.allsatcom.com/uploads/andrew/TYPE243_45003.pdf

There are tech drawings with dimensions in that file, however I'm not sure if you can work out the measurements you need from them. Hope it helps.

 

[gatonico]

Thank you for your help but the manual not have the measurements in addition the drawings are for the legs of data model of antenna C band which is different to ku model

Regards and wait any help with the measurements Please

Moderation Note - Please upload images - do not link to them

 

[gatonico]

Thank you for the help, but the manual have drawings of the data model antenna and not have measurements and i need the measurements of the normal ku model that is used for tv satellites and that many people in this forums have it

Regards and wait that anyone help me with the measurements of the legs please

 

[Channel Hopper]

Then why didn't you say so in the first place ?

From memory the feed support arms are the same on both Ku and C band, the feed support tube though is of a different construction on the C-Band version, using just a short rectangular/almost square stub with four holes, as opposed to the one pictured. Focal distance remains unchanged though.

 

[gatonico]

anyone have the measurements?

Thank you

 

[Channel Hopper]

anyone have the measurements?

Thank you

Measurements (imperial) are on page 15 of the manual link supplied.

 

[Terryl]

But they do not show the length for the side struts (thats what he is looking for, I think) I have contacted an engineer on this side of the big pond to see if he has a solution for him.(I hope)

Might take a few days, so please be patent Gatonico.

 

[gatonico]

no problem if i waiting for months that not wait some days

Regards and thanks

 

[Terryl]

Sorry Gatonico no luck with those measurements, they replaced those dishes several years ago.

If you could set it up like the drawing in the posted PDF file, you could get a good idea on what to use, setting the LNB and dish to the height shown will give the right measurement to the edge of the dish.

Bottom of dish is 11 inches above the ground, the bottom of the LNB mount is then set to 26.5 inches above ground, then making sure the LNB are is centered to the dish you will get the measurements you need.

This is the only way I can see to get this done.

 

[gatonico]

ok bad luck

Many thanks Terryl