Metronic Sat 100 flash problem

roaduser

roaduser

Member
My Satellite Setup
Mvision HD-270CN Sly oval and 80cm through Diseqc for astra 28.2 and 19.2. Technomate 6900 combo and Metronic for other rooms. Optical Audio for 5.1 through Technics receiver.
My Location
Lincolnshire
I couldnt get ITV HD on 119 only red button so I did a Flash with the latest software from Metronic. I now get all the channels, but it goes back to No channel found after night even leaving it on standby. Its looped through a Technomate but I have had no problems before. I have to rescan everytime I turn it on after a considerable amount of time.

Other people MUST have had this with the Metronic? Anyone?

P.S the Humax Foxsat update via satellite works fine.
 
As it's looped through form the Technomate, it is important that the Technomate is not active, otherwise you will get LNB switching conflicts.

TM must be in Standby when the Metronic is in use, if you want full function.

Have you tried taking the TM out of the loop overnight to see if the Metronic still acts up?

Not sure I understand the relevance of your "PS" ... where does a Humax Foxsat enter into this particular equation? Do we have all the facts?
 
cheers for advice, the P.s was the Humax works fine so Im a little disapointed the Metronic isnt as good, for those thinking of buying either. I did a re flash and this time left the power switched off(as instructed) for a long time rather than a quick pull out out in. Fingers crossed thanks for the reply.
 
Back
Top