Loquacious
Member
- Joined
- Sep 17, 2017
- Messages
- 170
- Reaction score
- 51
- Points
- 28
- Age
- 60
- Location
- Shoreham by Sea - West Sussex - UK
- My Satellite Setup
-
Motor : HD Line DisceqC Motor 50-120 ( apparently a Moteck SG2100A clone)
Dish : Dur- Line Aluminium 75/80cm
LNB : Dur - Line Twin
4. Receiver: Fortec Star HD Passion Plus ( 2010 )
5. WF 100 cable
- My Location
- Shoreham by Sea
Dear all,
First of all, I hope you are keeping well and safe. It's been quite a while since I came here for help.
Anyway, recently my motor dish is playing a bit as on day I moved to one of my satellites ( Astra 19.2 E) from( Hotbird 13.0 E) automatically and when I tried to move back on another day the motor didn't move to the satellite I wanted, instead went out of West limits and ever since I only can move manually.
I did what the manual said. Turn power, press and hold the East/West at the same time, turn on the power the light flashing , continue to push until the led stops flashing. Memory is erased. Motor is reset.
Nevertheless, from my receiver the motor still not moving. Not single mm.
What should I do next? Reset my receiver ( factory one ) and start again?
Many thanks
Loquacious,
First of all, I hope you are keeping well and safe. It's been quite a while since I came here for help.
Anyway, recently my motor dish is playing a bit as on day I moved to one of my satellites ( Astra 19.2 E) from( Hotbird 13.0 E) automatically and when I tried to move back on another day the motor didn't move to the satellite I wanted, instead went out of West limits and ever since I only can move manually.
I did what the manual said. Turn power, press and hold the East/West at the same time, turn on the power the light flashing , continue to push until the led stops flashing. Memory is erased. Motor is reset.
Nevertheless, from my receiver the motor still not moving. Not single mm.
What should I do next? Reset my receiver ( factory one ) and start again?
Many thanks
Loquacious,