Motorized 2.4 one piece solid dish.

A

audi-tek

Member
My Satellite Setup
TM6900 HD COMBO,1.2M MOTORIZED, DARKGOLD LNB
WINDOWS XP
My Location
Cobh,CO.CORK.EIRE
Hi to all.
Help needed from any one who has come across a 2.4 M MOTORIZED ONE PIECE SOLID DISH.It was made by EL MAHDY COMMUNICATION CO. IN EGYPT.I have such a dish and what to set up same. I am looking for any pictures or drawings or parts list of the set up.I have emailed the company in question for any information,but got no reply.Hope some one out there has some information of setup.
Cheers and thanks in advance.
 
what exactly do you need,are some parts mising?
when company is out of bisness,then you have no luck,finding this documents,
i have 20 year 2,20 dish from tragra,was a spain company,in barcelona,but on the net i found nothing!
so when some parts are missing,you must calculate the f/d ratio for example,and to iron factory,that they can make the missing parts for you,but currencly i dont know what exactly missing in your setup!

try do contact egypt sat dealers,hope the have more information for you!
good luck!
 
Hi Turok.
What i am looking for is a picture or drawing of the finished set up.Not certain that i have every part thats needed.The company that made it are still in operation,as i had to register,before i could send them an email.I was hopeful that maybe a member from Egypt, might have seen such at setup.
Cheers and thanks in advance
 
Hi Turok,
Not certain that i have all parts.Company is still in operation,as i had to register before i could email them.I am hopeful that maybe a member from Egypt,might have a picture or any drawings of a dish setup.Have seen loads of different pictures of similar size dishes setups but all are slightly different to mine.
Cheers and thanks
 
i dont know where egypt dude is,long time not see him here on board?
try to call the company,this is sometimes the better way,to get answers to question,then via mail!
 
Yea Turok,
Guess i will have to try that.Knowing my luck,they wont have a word of english, when i do make contact.Give them a ring in the morning.
Cheers and thanks
 
didn't you get a drawing from a member of another forum
 
Hi shane 77,
That is correct,but it a rough drawing of what way i should be going about the setup.Its not an actual drawing of my dish.If i could get my hands on the original drawing or parts list,it would make life a lot easier.Rang the company today on two different numbers,but couldnt get through.The good news is that i might have located a setup of a similar dish about ten miles from me ,wont know for certain till a person confirms its the same setup as mine.He is 99% certain that they are both the same,
Cheers and thanks
 
Back
Top