Muddywellies
Member
- My Satellite Setup
- Penta 85 Moteck SG2100A TM6900HDCombo Invacom SNH-031.
PC stuff nothing special.
- My Location
- N. Devon, UK
Here are a few pics of my first DIY satellite installation.
The first view is a general view of my gable wall facing due south. The reference set up sat was Atlantic Bird at 5W.
I'm rather nervous at any height above terra firma so 8mm rawl bolt hooks were used to secure the ladder using steel wire - seen on the 4th rung down - the bolt were left in the wall for future use.
Second shot is a close up shot of the wiring with the four dish bolts shortened to prevent the cables being pulled out when traversing. Electrical insulating tape is used to reinforce the water resistance properties of the ill-fitting rubber grommets until I visit an electrical supplier for amalgamating tape.
Third image image is another close -up.
The first view is a general view of my gable wall facing due south. The reference set up sat was Atlantic Bird at 5W.
I'm rather nervous at any height above terra firma so 8mm rawl bolt hooks were used to secure the ladder using steel wire - seen on the 4th rung down - the bolt were left in the wall for future use.
Second shot is a close up shot of the wiring with the four dish bolts shortened to prevent the cables being pulled out when traversing. Electrical insulating tape is used to reinforce the water resistance properties of the ill-fitting rubber grommets until I visit an electrical supplier for amalgamating tape.
Third image image is another close -up.
