Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Need help, replaced old dish with new 1.2M
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tornado-Odessa" data-source="post: 172971" data-attributes="member: 200175"><p>Thanks,</p><p>I think I understand what your trying to do here, but you must understand I do not have any tools like a signal finder, etc... </p><p></p><p>My thoughts above were that if I have a signal from 28.2 then it gives me a reference point. I hesitate to move the motor or anything else in a horizontal position. Vertically, I can always get it back if I mess up by putting it back were it was. I understand that moving the motor on the pole 2 degress west, you are thinking that will line it up with 30E which is my real due south, correct ?</p><p></p><p>So I can drive the motor 2 degrees west, then rotate the motor on the pole until I get the 28.2 signal back, is that correct ?</p><p></p><p>Then I can set the motor angle to 46 LAT, and adjust the dish angle ..</p><p></p><p>That should do it right ? or am I way off ?</p></blockquote><p></p>
[QUOTE="tornado-Odessa, post: 172971, member: 200175"] Thanks, I think I understand what your trying to do here, but you must understand I do not have any tools like a signal finder, etc... My thoughts above were that if I have a signal from 28.2 then it gives me a reference point. I hesitate to move the motor or anything else in a horizontal position. Vertically, I can always get it back if I mess up by putting it back were it was. I understand that moving the motor on the pole 2 degress west, you are thinking that will line it up with 30E which is my real due south, correct ? So I can drive the motor 2 degrees west, then rotate the motor on the pole until I get the 28.2 signal back, is that correct ? Then I can set the motor angle to 46 LAT, and adjust the dish angle .. That should do it right ? or am I way off ? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Need help, replaced old dish with new 1.2M
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top