Programming Cams..

N

Nolia

Regular Member
Joined
Apr 9, 2009
Messages
86
Reaction score
0
Points
0
Age
42
My Satellite Setup
Moterk 2100A motor on Cyfra+ 80cm dish,45'E-37.5W Technomate 6800 HD receiver(Normal).
Windows 7 and Linux.
My Location
Buckinghamshire(H.Wyc)
Just a quick one to the technology boys. If u install Linux Os on a laptop that has a PCMIA port is it possible to program a CAM? As Linux is open source software
 
M

Mickha

Super Moderator
Staff member
Joined
Dec 10, 2004
Messages
5,986
Reaction score
895
Points
113
My Satellite Setup
1.2M Channel Master, 1224 motor, VU+ Duo 2
My Location
North West
Some older Cams can be programmed using the PCMIA slot on your laptop, but as these are no longer of any use it's pointless, newer cams require a programmer, the best being the Cas 3+, or newer, programmer, as these can program both cams and cards.
As there is hardly anything available, at the moment, it would be ebst to wait a short time before investing in any new equipment.
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Joined
May 1, 1999
Messages
38,296
Reaction score
1,620
Points
113
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
With some older CAMs, it could be done on a Windows 98 laptop, but don't think you'd have much joy with the newer CAMs, as I don't believe there are any loaders available.


Edit. Beaten to the punch.:)
 
N

Nolia

Regular Member
Joined
Apr 9, 2009
Messages
86
Reaction score
0
Points
0
Age
42
My Satellite Setup
Moterk 2100A motor on Cyfra+ 80cm dish,45'E-37.5W Technomate 6800 HD receiver(Normal).
Windows 7 and Linux.
My Location
Buckinghamshire(H.Wyc)
ok gents thanks for the advice...
 
Top