Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Setup Advice - Sky Dish
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="GBH" data-source="post: 790528" data-attributes="member: 385364"><p>I have tried what you suggested but still no signal being received at the TV. I remade the cable ends and screwed in tight. I checked that there was no braid touching the copper core. I made sure that there was about 5 mm length of conductor showing clear of the F plug and even bent the tip of the copper conductor over slightly to make sure it made good contact inside the LNB and Receiver connections. I have the cable running from the LNB to the receiver in one piece with no intermediate joints along it to avoid any problems with additional joints. I have tried the dish in all positions suggested and also tried it with a signal meter. I get a high reading on the meter when the satellite is pointing in the correct direction but no signal on the TV. I am unsure whether the LNB is defective, because I am getting a good response from the meter. Perhaps it is the receiver that is at fault. Any ideas? Thanks. Gary</p></blockquote><p></p>
[QUOTE="GBH, post: 790528, member: 385364"] I have tried what you suggested but still no signal being received at the TV. I remade the cable ends and screwed in tight. I checked that there was no braid touching the copper core. I made sure that there was about 5 mm length of conductor showing clear of the F plug and even bent the tip of the copper conductor over slightly to make sure it made good contact inside the LNB and Receiver connections. I have the cable running from the LNB to the receiver in one piece with no intermediate joints along it to avoid any problems with additional joints. I have tried the dish in all positions suggested and also tried it with a signal meter. I get a high reading on the meter when the satellite is pointing in the correct direction but no signal on the TV. I am unsure whether the LNB is defective, because I am getting a good response from the meter. Perhaps it is the receiver that is at fault. Any ideas? Thanks. Gary [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Setup Advice - Sky Dish
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top