- Forums
- Satellite TV receivers & systems support forums
- DISH SETUP: Single sat, Multi-Sat & Motorised
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Small motor problem
- Thread starter jpsr
- Start date
jpsr
Regular Member
- My Satellite Setup
- 1.2 channel master, cm polar mount, 12 inch actuator, Andrews feedhorn, Inverto lnb, Superjack positioner, Dreambox dm 500s, Protek 9600ip, 1m channel master with black ultra & 1m gibertini with technomate twin output lnb on astra 1/2, TM 5200 & 1000
- My Location
- Mullingar, Ireland
Tivù said:Yes - but as I've only just seen your Post and some later ones, I'm guessing you have bought it, applied it, read the T-Short and got the Book!
Not sure what your message means, but anyway, i havent ordered it yet.
jpsr
Regular Member
- My Satellite Setup
- 1.2 channel master, cm polar mount, 12 inch actuator, Andrews feedhorn, Inverto lnb, Superjack positioner, Dreambox dm 500s, Protek 9600ip, 1m channel master with black ultra & 1m gibertini with technomate twin output lnb on astra 1/2, TM 5200 & 1000
- My Location
- Mullingar, Ireland
Channel Hopper said:Don't believe the figures given, that's a human inerface thing. Are you getting the same sort of BER figure with any other receiver (the 5200 ?) when you move into the weakest channel you can get on your dish from either side ?
Not sure, i will re connect the technomate later and post back.