Superjack VboxII

H

hudspau

New Member
Joined
Jun 21, 2013
Messages
2
Reaction score
0
Points
1
My Satellite Setup
Techno mate and triad motorised dish and a channel master motorised dish
My Location
morley leeds w yorkshire
Hi, Am having problems programming my superjack vII to my 1224 supermount,using a technomate t2 how do I store the memories?
 
Costactc

Costactc

Regular Member
Joined
May 30, 2012
Messages
811
Reaction score
763
Points
93
Age
58
My Satellite Setup
3m channel master mesh-24" vonweise actuator-ps1 x2 lnbf(L)-pansat ap3500 positioner-x2 premium III-vu+solo2.
2.4m fortec solid-24" vonweise actuator-esx 241 lnbf(c)-vbox 7 positioner- dm800.
1.2m fortec-24"sj actuator-invacom snh-031--tm 5402 m3.
My Location
Canada
I haven't used a vboxII in about 5 years but I used to assign a number for each saved satellite- stand alone.
 
Vipersan

Vipersan

Emmett Browns Ghost
Joined
Jun 29, 2009
Messages
10,918
Reaction score
6,663
Points
113
Age
66
My Satellite Setup
IP9000HD +
TD110 Dish and TD88 Dish in Tandem
66°East to 60°West.
AZbox PrmHD + OpnbxS9HD + Skybox + DrHD F15
2x VboxII AZ-EL
2 m+ Alcoa PF + BSC421 C-Band lnbf...
+SS2/TwHnS2-3200 pci/TBS6925 pci
1.5 Fortec Star -Gbox - HtoH Ku/Ka/C
My Location
UK
You may be assuming the memories are stored in the Technomate ..
They aren't ..
The actual memory position of a satellite position is stored in the Vbox memory ..and referenced ..or 'called' from the receiver ...byr sending a diseqc 1.2 command down the lnb cable to the Vbox ..
So Either you can set the receiver to diseqc 1.2 mode ..and tell the Vbox to store a satellite position..via the receiver ..this is usually done sequencially ...
OR ..you can store the positions in the Vbox manually using the remote controll ..then 'call up ' these stored positions using the receiver once the references are edited into the Technomate by using a channel editor..
Hope this helps.
rgds
VS
 
Top