Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Supporting Mast
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="A Lancashire Lad" data-source="post: 989093" data-attributes="member: 402648"><p>Receiver is set for Usals. I used the reciever to drive motor to 1w then rotated the motor on the pole and found Thor as can be seen from the picture above I then sent the motor to 28.2e and it found it ok. I then used goto 0 and then to Thor and it could not see it so went to Astra could not see it. So used the manual buttons on the motor to move the dish to the satellite took several presses of the button to get it to line up. dont think the motor is counting the pulses correctly it's boxed up going back to supplier. If the importers gone bust it could have been a faulty return that made it's way on to the market after the companies assets were sold off .</p><p>The receiver should have driven the motor back to the same position that I had located the two sats in the first place as the receiver drove the motor to those locations when I first setup.</p><p>Apparently there are counterfeit Moteck & Jagear motors doing the rounds as well</p></blockquote><p></p>
[QUOTE="A Lancashire Lad, post: 989093, member: 402648"] Receiver is set for Usals. I used the reciever to drive motor to 1w then rotated the motor on the pole and found Thor as can be seen from the picture above I then sent the motor to 28.2e and it found it ok. I then used goto 0 and then to Thor and it could not see it so went to Astra could not see it. So used the manual buttons on the motor to move the dish to the satellite took several presses of the button to get it to line up. dont think the motor is counting the pulses correctly it's boxed up going back to supplier. If the importers gone bust it could have been a faulty return that made it's way on to the market after the companies assets were sold off . The receiver should have driven the motor back to the same position that I had located the two sats in the first place as the receiver drove the motor to those locations when I first setup. Apparently there are counterfeit Moteck & Jagear motors doing the rounds as well [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Supporting Mast
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top