Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Techomate M5402 M3 and Diseqc setups
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jeallen01" data-source="post: 975797" data-attributes="member: 176704"><p>A33</p><p></p><p>Because the instructions state that Mode 1 is for receivers with Diseqc 1.0 control (only), I started in Mode 2 which is for receivers with both 1.0 and 1.1, later tried Modes 3 & 4, and then went back to Mode 2 because of the "moving to" messages. I did not try putting dipswitch 4 to ON because I'm not cascading external switches after the EMP.</p><p></p><p>Don't think the TM has the menu options to which you referred, but I doubt the voltage issue applies because there is less than 10m of cable between the EMP and the receiver, and less than 3m between the EMP and 2 of the 3 BEST switches (the other one is further away).</p></blockquote><p></p>
[QUOTE="jeallen01, post: 975797, member: 176704"] A33 Because the instructions state that Mode 1 is for receivers with Diseqc 1.0 control (only), I started in Mode 2 which is for receivers with both 1.0 and 1.1, later tried Modes 3 & 4, and then went back to Mode 2 because of the "moving to" messages. I did not try putting dipswitch 4 to ON because I'm not cascading external switches after the EMP. Don't think the TM has the menu options to which you referred, but I doubt the voltage issue applies because there is less than 10m of cable between the EMP and the receiver, and less than 3m between the EMP and 2 of the 3 BEST switches (the other one is further away). [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Techomate M5402 M3 and Diseqc setups
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top