Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Techomate M5402 M3 and Diseqc setups
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="a33" data-source="post: 975944" data-attributes="member: 332642"><p>So, you say that repeated switching at diseqc 1.0 level <u>within</u> one EMP port gives no success either. </p><p></p><p>Alas! Then the EMP doesn't pass through the diseqc signal, or somewhat distorted? Or the BESTs are slow to start up, and go in an erratic state of just port 1? (Did you try this also with your SPAUN?) </p><p>OK, could be an unsolvable compatibility issue......</p><p></p><p>Having the 1.0 switch near your receiver, and the 1.1 switch near the LNB's doesn't help you here either, as you have only one 1.1-switch (So just 7 switch-possibilities then)? (That is, if your receiver repeats commands, or sends them that order.)</p><p></p><p>What is the diseqc mode of your Opticon 10/1? Can't you use that in a cascade?</p><p></p><p>Nice that you can have your money back!</p><p></p><p>Greetz,</p><p>A33</p></blockquote><p></p>
[QUOTE="a33, post: 975944, member: 332642"] So, you say that repeated switching at diseqc 1.0 level [U]within[/U] one EMP port gives no success either. Alas! Then the EMP doesn't pass through the diseqc signal, or somewhat distorted? Or the BESTs are slow to start up, and go in an erratic state of just port 1? (Did you try this also with your SPAUN?) OK, could be an unsolvable compatibility issue...... Having the 1.0 switch near your receiver, and the 1.1 switch near the LNB's doesn't help you here either, as you have only one 1.1-switch (So just 7 switch-possibilities then)? (That is, if your receiver repeats commands, or sends them that order.) What is the diseqc mode of your Opticon 10/1? Can't you use that in a cascade? Nice that you can have your money back! Greetz, A33 [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Techomate M5402 M3 and Diseqc setups
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top