Log in
Register
Menu
Log in
Register
Home
What's new
Latest activity
Authors
Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Satellite Meters and Installation Equipment
Using the "138MHz-4.4GHz USB SMA Source/Signal Generator/Simple Spectrum Analyzer" for TV/CATV/SAT
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="vma" data-source="post: 1070796" data-attributes="member: 256592"><p>Hello,</p><p></p><p>The software only works with SMA/NWT/D6 devices. These cost between 50-200 Euro and you need to buy them on Ebay or AliExpress. I think you will find them on Amazon, too.</p><p></p><p>In order to use them for satellite TV, you connect the LOOP THROUGH connector from your satellite receiver (or a "T" connector) to a DC Blocker (very important to not destroy immediatly the M810 IC) to the INPUT connector of the SMA/NWT/D6 device.</p><p></p><p>Changing Polarity/Low-High and DiSEqC is done on the receiver.</p><p></p><p>Regards,</p><p>Vitor</p></blockquote><p></p>
[QUOTE="vma, post: 1070796, member: 256592"] Hello, The software only works with SMA/NWT/D6 devices. These cost between 50-200 Euro and you need to buy them on Ebay or AliExpress. I think you will find them on Amazon, too. In order to use them for satellite TV, you connect the LOOP THROUGH connector from your satellite receiver (or a "T" connector) to a DC Blocker (very important to not destroy immediatly the M810 IC) to the INPUT connector of the SMA/NWT/D6 device. Changing Polarity/Low-High and DiSEqC is done on the receiver. Regards, Vitor [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite TV receivers & systems support forums
DISH SETUP: Single sat, Multi-Sat & Motorised
Satellite Meters and Installation Equipment
Using the "138MHz-4.4GHz USB SMA Source/Signal Generator/Simple Spectrum Analyzer" for TV/CATV/SAT
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top