Recent content by bella

I take it there is no updated firmware for it in your forum. Is this right?

Hi, The make is SMART F3 HARDWARE MODEL 512K Flash Hardware Version GX6101 DVB-S V1.0 Software Version SMART V1.0 Production date APRIL16,2008 If there is not updated firmware for it may be you can provide me with the latest soft keys. Regards

Hi, I take a note that this is a loader and I should not use it. But where can I get the firmware for my STB?

Hi, I have a rather similar problem. I have an STB with the same microchip here are the details:- EON 29LV040A 70JCCP W-ch WCT. ISI ISH-8 02PMW8J AMS 1111 TB 0812 Motherboard ID GX6101+ZL10039 V8.7B Hardware Model 512K Flash Hardware version GX6101 DVB-S V1.0 Software version...

I think I might have a problem with the LNBF on my C-Band Dish. How can I quickly check if my LNBF is active and not burnt?. It is a C-Band LNBF L.O. frequency 5150Ghz dual polarity. My dish is motorized how do I put the skew angle? on Zero parrallel to the pole, or do I have to tilt it left or...

I asked my friend to lend me his receiver to try it on my installation. I tried the same channel he had it on and I am getting the signal strength is too weak. Which means I need to recheck my C band installation. I will let you how it goes. I will going through a process of elimination and if...

What about the other frequencies. Looking at the same Lyngsat list and go to 3760 H. Services such as Bloomberg, MTA International and Al Jazeera English. I tried all of these and none came up. Does this mean that these services are also out from the satellite? I do not understand the...

Thank you again. My apology it is AsiaSat 3S and not "c" I am not getting any signal quality from the transporder on the receiver, but on my satellite finder meter I am getting a good reading and a high pitch sound. I even changed settings to Asiasat 2S because both transporders are very close...

Thank You Robbo. I ended up inputting the transporder frequency, the symbol rate and the video and audio PIDs manually. The receiver searches and picks up the frequencies and records them in the channels list but there is no image or sound. Instead I get the E48 no signal. It is a bit weard...

I purchased a second hand Topfield 3200IR. I tried it on my existing system, which is working fine, it gave me an error message " E48 no signal" I took the receiver to my friends house who has a similar working system and tried it. I got again the same error sign. Is the STB bad? not working...

Hi, Thanks. I tried it . The boot loader is not loading the software. or the flash or chip processor is not responding to the boot loader. What can I do ? How can I check my flash memory in the receiver? Thks.

I have a big problem with my firmware on my GS-1590 Digital Satellite Receiver. It uses a Fugitsu processor. I was trying to download a softcam software with a file extension .DLD. It accepted it but then it did not reboot and got stuck. I tried to reload the original software but it is...