Recent content by credcrunching

i'll try, but i won't mind a pic of the non-component side of tm9100's mainborad. to facilitate track tracing.

i'll be grateful if someone can post service manual. thanks

just discovered only horizontal channels are available after scanning 1W and two damaged lnbs and moteck motor. i can put this down to loose earth wire of the main power plug.my tm1500 and humax 5100 are behaving like my tm9101.I've taken the voltage reading of stb f-connector and it turns out...

tried that already and i got VCR 7D2D DK.. . googled it but no luck. i experimented with something of the same size with 104z marking and got the green light. But it was unable to move the dish. any clue as to what 7D2D DKF(E) means will be appreciated

just wanna make use of the moteck motor photos posted above. my motor was smoking and when i opened up i found a burnt out blue disc-like component labelled com2(i think com1 is the same as com2).i would like help to identify it.com1 clearly visible and com2 is barely visible .