Recent content by KEB

  1. K

    LCD TV Questions

    Hi All, Many thanks for the replies. Despite thinking the Phillips was dead, I managed to get it repaired. However, all the info is most valuable as I don't think I will be able to get it fixed again and so a new set will become inevitable at some point. All the best, Kristian
  2. K

    Panasonic DMRES 15

    Hi All, As I said in the Tosh post, I am looking for a new DVD recorder. I had a look at the Panasonic DMRES 15 today and was quite impressed. Does anyone have any opinions on this one ? Thanks in advance, Kristian.
  3. K

    Toshiba DR160

    Hi All, I am looking for a new DVD recorder and came across the Toshiba DR160. It looks good value for money, especially as it includes time slip recording. Does anyone have any opinions either good or bad about it ? All the best, Kristian.
  4. K

    LCD TV Questions

    Hi All, Our old 24inch Phillips TV has finally given up the ghost so a replacement has got to be found. We have looked at most of the available LCD 28inc + flat screens in the various big name stores and small independents but we are getting a lot of conflicting infomation and opinions. Our...
  5. K

    Nederland 1

    In pursuit of my interest in European Railways, I have discovered that Nederland 1 carries a rail interest programme. Can anyone please tell me where I can find this channel. I have a motorised system, but need to know where to start looking. All the best, Kristian. UK.
  6. K

    DISEqC Setup

    Thanks to all who replied to my question. After re locating the dish and adjusting, every thing fell into place. Thanks again, Kristian.
  7. K

    DISEqC Setup

    Hi Rolf, Thanks for your reply and apologies for a couple of typos that I noticed sneeked in. I would like to try the stand alone pole again as it is in the very best position. Is there any restriction on the length of cable as it will have to run over 90ft from dish to receiver ? So far on the...
  8. K

    DISEqC Setup

    Hello, We have just installed a Moteck SG 2100 DISEqC motor. The dish is in the same position as previously, perhaps six inches lower due to the motor tube. The location is on the wall of an outbuilding six feet above the ground between two bulidings and facing south. Before we fitted the...
Top