Thanks for your reply. The independent viewing option got me thinking and I decided to directly connect the second cable from the dish to the cable running from the living room to the bedroom. I will now start looking for a freesat receiver to attach to this cable. Thanks again.
Les
I have recently moved house and the new abode has a quad LNB with two cables running from it into the living room and a further cable running from the living room into a bedroom. My old setup was a dish with a single LNB connected to an ordinary Sky box. If I purchased a Sky+ box and connected...
I have had a bit more time to try and solve this recently. The motor will turn the arm to the East either by STB or direct motor control but when I try to turn the arm back to the West the sound is like a flat battery in a car and after a couple of minor movements the light goes from green to...
My motorised dish started playing up a couple of days ago. It had moved to the far extremity East and would not budge. I did a factory reset of the STB to see if this would solve the problem but it did not.
I looked up a couple of archive documents on your site that gave some clues as to what...
I am contemplating taking up a Sky subscription.
Is there a Satellite Receiver on the market that can be used to view Sky using an official sky subscription card that can also be used to view channels from other satellites with a motorised dish? I don't want the clutter of having a Fortec + a...
Thanks Rolf for the information. I will have to have a rethink. If I chose a 90cm aluminium dish could I use the pole and have the dish at a slightly lower level or is it that the pole is too thin at any height for the motor and dish.
Les
I currently have a Fortec 65cm Dish on a Metronic motor mounted on a 5cm diameter pole with the bottom of the dish about 4.5 feet above the ground. To stop getting hassle from my other half I have agreed to raise the dish so that the bottom of the dish is not lower than 7 feet and I have bought...
Good news.
Firstly I must apologise to the installing engineer for my misgivings. He came round to offer a loan of his receiver until my problem was fixed.
However, the problem was due to old software within the receiver and now I have exchanged the Lifetime Classic for a Lifetime Diamond and...
I am not sure that I can just go to a DiseqC1.2 menu and do a manual search on the Fortec Lifetime Classic. I have to go into Installation, Antenna Setup, choose a satellite, change the dish from fixed to motor and then get a Positioner DiseqC screen. This is the one that does not respond until...
I have altered my dish to latitude 51 for my location and adjusted the dish's angle to get a good signal on Thor. From there I got a good signal for Hotbird too.
However, if I want to move the dish for Astra 2D I have to disconnect the LNB cable from the motor, reset the dish to 0 and move to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.