Recent content by r4lph

Does anyone know the most actual original software version for the MasterCRD3 programmer? I have MCRD3 Burner 1.004 and I cannot check if it is a recent one as the manufacturers website www.mastercrd3.de is down. thx r4lph

I checked the programmer with a few funcards and it fails to operate succesfully. It seams it's defective and I send it back to the dealer by tomorrow. thx again to all who tried to help me r4lph

@gjones thx for that advice. I tried to erase my titanium with Titaniumloader from TJ1965 both V1.0 and V1.1 already without success. It displays "Trapping card.." and after about 20 minutes "Trapping card failed." My MasterCRD3 was set to phoenix mode at 3.58MHz and i gave it a second try in...

When I connect to the programmer with Titanium Card Progger I got "No ATR ! unsupported Titanium OS found." So I believe there's no ATR. I'm not sure now if my programmer is ok. I do not have any other cards here at the moment to check. thx for the suggestion r4lph

@guiri no I didn't

in addition I tried to downgrade and upgrade with Titanium Updater 2.0. Got stuck at "Trapping titanium card... please wait" :-( r4lph

@guiri thx for the suggestion. I gave it a try with TMB 1.8.3 and it came up with the message "No CARD !!!" after I pressed ERASE TC. I double-checked it with another titanium, same result. Both of the cards tested by the dealer to be ok. thx neway r4lph

@razor thx for that advise. I actually tried Card Progger from V1.5 up to V1.10.2 without any success. Card Progger is using my CPU's bandwith to 100% all the time while erase is started. Is that normal? regards r4lph

I read all information here and in other forums concerning the problems erasing the blue titanium card (trapcode error). I tried to follow the suggestions but couldn’t get past “sending trapkey” while erasing the card with Titanium Card Progger V1.10.0. I’m on XP-home 2GHz Intel Pentium 4 using...