Yes Im using the TM500Super and a 85cm dish will update profile. Looks like I may need a better reciever then to pick these up? Im thinking of going for a tm 800hd soon. So hopefully I will be able to get these..
Hi folks can anyone tell me why on my 85cm dish from the north west of the UK why I can pick up some transponders on the euro beam and not others. Some are perfectly strong whilst others I cant even get a signal on.
I Had a go at getting the Slovak Sport channel last night, and although I can...
I can report it wasnt a dodgy icecrypt; but i have reduced the BER to 0 (yes 0!) on all those that were seemingly troublesome. By driving to the Sat via usals then going into the motor setup then moving the dish using the fine tune option either E or W I managed to reduce BER step by step down...
Thanks lads im getting there slowly, its a bit of a learning arc (bad pun i know). Would squewing the lnb whilst at 28.8 by that much ("4 oclock") then mis squew it for the rest of the sats when moving through the arc? I would have thought it may properly goose it for the rest of them?
ps. its...
Hi folks
Answer: Id duffed the alignment initially and was being inpatient assuming using the figures from the box would be easy enough to perform alignment....I suppose the the result of this will help future noobs not make the same assumption I did. So many thanks fr all the help. Golden...
Hi hopper, the tape was an extra measure of mine under the amalg. tape to repel water etc (maybe seemingly abit over kill). Its over the f connector fitting upto the neck of the nut, rather than under the fitting if thats what you mean. I plan to retape up the setup once ive got everything tested.
Im inclinde at this point to agree with you on this, maybe I will wait till my Meter arrives and crack on from there and if the issue is still around continues report back (or indeed report back if sucessful!). Thanks all of you for the help so far folks. I should have the meter Thursday so I...
It sounds more like an alignment issues then, possibly ive missed something, will get the camera out tonight as well. I have a sat meter coming so maybe this will help me. Next step I will firstly double check the motor lat is on 53 for my sanity, then tightenup the dish bracket to 24 get the...
Hi Tivu
Many thanks for the advice again.....you will have to bear with me as Iam a noob still on a learning mission
The low readins are failure to lock, I cant seem to get close to a signal frm thor (or indeed an sat) no matter where I move the dish to. The Lat on the motor is set to 53 as...
Hi folks,
having tried squewing the lnb a few times tonight, im afriad nothing is changing, Its back to the drawing board for me. Ive a sat meter coming this week so at least I can test if the lnb isnt faulty.....
Hi matey
Just a bit confused by what your saying,
Iam assuming that what you are saying is these LMBs could \ have been manufactured slightly wrongly and the zero skew on the unit isnt correct or in the usuual position. And to offset this problem I need to skew the LNB to the "actual" zero...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.