spike47
Member
- Joined
- Jan 13, 2013
- Messages
- 14
- Reaction score
- 1
- Points
- 3
- Age
- 57
- My Satellite Setup
- Sky dish on Freesat and Aerial on Freeview .both piped down to lounge TV and Bed 1 and a Sat cable to Bed 2 .
- My Location
- Skelton , Saltburn-by-the-Sea Yorkshire
Hi All
I have just fitted a Labgear 2 Way Masthead Amplifier PUL121 ( Picture Attached ) , to take a feed to a: Lounge TV , b: TV for Daughters Bedroom .
I have a 12 Volt feed from the Lounge TV up to the Masthead Amp , but I am not getting any signal to TV , I have checked the Continuity of the Cables and they check out OK , and I am getting 12 V at the Masthead .
Question , is there a way to test the PUL121 , is there any reading's I can check on it . I have only just bought it and I really wanted to know if there was a problem with the Unit before I try to take it back , if I can that it .
Note : I have taken a 1 way Masthead amp off that worked ok on my Lounge TV .
spike
I have just fitted a Labgear 2 Way Masthead Amplifier PUL121 ( Picture Attached ) , to take a feed to a: Lounge TV , b: TV for Daughters Bedroom .
I have a 12 Volt feed from the Lounge TV up to the Masthead Amp , but I am not getting any signal to TV , I have checked the Continuity of the Cables and they check out OK , and I am getting 12 V at the Masthead .
Question , is there a way to test the PUL121 , is there any reading's I can check on it . I have only just bought it and I really wanted to know if there was a problem with the Unit before I try to take it back , if I can that it .
Note : I have taken a 1 way Masthead amp off that worked ok on my Lounge TV .
spike