2 digiboxes - lnb - no signal on 1

  • Thread starter Thread starter daveb
  • Start date Start date
D

daveb

Guest
Hi

I am very new to this game , can anyone advise. I have a PACE digibox , a Amstrad digibox and a signal splitter and the appopriate cables. I can have either digibox live but if I have them together 1 gets signal , the other doesn't , just gets an error message "For Your Information" "No Satellite Signal received" .
What am I doing wrong , or what do I have to do to get signal. I was getting signal on both initially but then this issue started.

Many thanks

Dave
 
Amstrad (early) receivers are notorious for forgetting the LNB voltage or tone settings if disconnected from the LNB, even if only momentarily. Im sure if you unplug and reconect it all comes back.

The Pace may or may not be in a similar position
 
daveb said:
Hi

I have a PACE digibox , a Amstrad digibox and a signal splitter and the appopriate cables. I can have either digibox live but if I have them together 1 gets signal , the other doesn't , just gets an error message "For Your Information" "No Satellite Signal received" .

Dave
Click to expand...

A signal splitter? not possible for correct operation as a 13/18v and tone is sent out by the digibox to control the V/H polarity and band switching.

If one port of the splitter is "though power" it will control the LNB and provided that both receivers are on the same polarity signal should go to both.

The only satisfactory way to run 2+ boxes is with a twin or quad LNB.
 
Had the same problem Dave with two digiboxes. Drove me mad because I could get the signal on one then the other but not both and got all your error messages as swell. In the end it's not technically possible or advisable. It was solved by the use of the Quad LNB.
 
Back
Top