5 volt optical sensor

D

Donnie Ban

Member
My Satellite Setup
Echostar LT8700 (analogue)with a Highway 120 Dish
My Location
North of Scotland
As my v box does not have a 5 volt sensor connection, can I connect an alternitive 6 volt supply to the motor, or is 6 volt to heavy, I did try it on the bench for a second and it did worked ok, but I am not sure what it would like long term.
 
Thread moved from Site Access / Membership Problem section.
 
Donnie Ban said:
As my v box does not have a 5 volt sensor connection, can I connect an alternitive 6 volt supply to the motor, or is 6 volt to heavy, I did try it on the bench for a second and it did worked ok, but I am not sure what it would like long term.
Click to expand...

A more elegant solution would be to find a +5V source in your v-box and take it out to a terminal fixed somewhere on the case.
 
Or if you don't want to open your VBox, an LM7805 would help (5v regulator IC)
 
Thanks for your help, if I open the box where would I find a +5 volt source on my Moteck vbox II
 
Not having one, and no schematics appear to exist, I can't point to a particular spot.

Nevertheless, a visual check might find a +5V regulator (LM7805 or similarly marked component). Or a check with a voltmeter for a +5V supply line.

If no luck, you will probably have to tap into a higher voltage point (possibly a 12V line) and add a +5V regulator yourself.
 
There is a 5v rail in all Vbox machines, and it is derived from a generic three pin regulator
 
There you go then. Thanks CH.

Adding a current limiting resistor (68 ohms should be OK) in series with the line taken out will prevent any short-circuits etc. on the line causing problems in the v-box
 
Thanks for the replies I will check it out
Donnie
 
Back
Top