misterminibus
Regular Member
- My Satellite Setup
- Kodi
- My Location
- Lancashire
Does anyone know how to add the lat/long on a Triple Dragon I seem to be going in circles in the menus ?
Add lat/long on a Triple Dragon
- Thread starter misterminibus
- Start date
- My Satellite Setup
- Triple Dragon, Dreambox 8000, Echostar AD3000ip, TBS6522,6925,6983 PCie cards.
Gibertini 1.25m motorised dish driven by the AD3000, with either Inverto BU Quad or Norsat / XMW Ka LNBs . SMW 1.05m + 3 other dishes. Speccy: Promax HD Ranger+
- My Location
- The Flatlands of East Anglia
I don't use a DiSEqC motor, but in the Menu, if you go to DiSEqC & Rotor Configuration, enable Rotor Support. Then Attached to - Rotor.
In Rotor Installation, set your satellites to their Latitude and Longitude positions.
In Rotor Installation, set your satellites to their Latitude and Longitude positions.
misterminibus
Regular Member
- My Satellite Setup
- Kodi
- My Location
- Lancashire
In DiSEqC & Rotor Configuration
I have
Rota support "DiSEqC Ku & C band "
attatched to "directly connected"
But where is the option for lon/lat please ?
I have
Rota support "DiSEqC Ku & C band "
attatched to "directly connected"
But where is the option for lon/lat please ?
- My Satellite Setup
- Triple Dragon, Dreambox 8000, Echostar AD3000ip, TBS6522,6925,6983 PCie cards.
Gibertini 1.25m motorised dish driven by the AD3000, with either Inverto BU Quad or Norsat / XMW Ka LNBs . SMW 1.05m + 3 other dishes. Speccy: Promax HD Ranger+
- My Location
- The Flatlands of East Anglia
Without messing up my settings to check, I think it's 'Adv. DiSEqC' where you set your co-ordinates that you have presumably set your dish motor to (reference satellite).