Licinius
Regular Member
- Joined
- May 31, 2006
- Messages
- 93
- Reaction score
- 0
- Points
- 0
- Age
- 55
- My Satellite Setup
- Technomate 1500CI+
- My Location
- Andalucia, Spain
I have my system assembled on the floor ready to mount today, the only bit which I'm confused about is the angle of declination. According to the instruction manual on my motor (Technomate TM-2100A) it needs to be 22.4 (I understand that bit).
The problem is when I come to set my dish bracket. The only mark I have on the bracket is in the bottom right hand corner, if I use this to set the angle then the dish is pointing below paralell !
Should I set the dish to approx 22' elevation? I have a meter anyway so can fine tune as I'm fitting the dish but I'd rather have it set as close as possible before starting.
Thanks for your help guys.
The problem is when I come to set my dish bracket. The only mark I have on the bracket is in the bottom right hand corner, if I use this to set the angle then the dish is pointing below paralell !
Should I set the dish to approx 22' elevation? I have a meter anyway so can fine tune as I'm fitting the dish but I'd rather have it set as close as possible before starting.
Thanks for your help guys.