Manikm909
Small'ish Dish Man
- My Satellite Setup
- Channel Master 1.8M on Edision MIO 4K & GTMEDIA Combo, and CM1.2M on Octagon SF8008
- My Location
- Kent, UK
Help Required Bolt under actuator
- Thread starter Manikm909
- Start date
nelson_b
Contributor
- My Satellite Setup
- Strong 4375 driving a 2.4 m Channel Master dual focus offset + Invcom Quad C120 K/U l.n.b. + BSC 421 and Zinwell C band l.n.b.,s - DR HD F15 - TM5302 - Octagon SX88+Optima - GT Media V7 - HD receivers. + other dishes currently in use - Antique 3.0 m Prodelin P.F. - Channel Master 1.8 m offset - Channel Master. 1.2 m.
- My Location
- North West Yorkshire - near Lancashire & Cumbria borders.
scopus
Specialist Contributor
- My Satellite Setup
- Primesat/Famaval 1.8 PF C/ku/Ka, Octagon SX8HD1, SX88, Openbox S3 Mini HD-V8S Freesat V7 HD-V8 Finder, Amiko A4K Combo, Satlook Colour HD Spectrum, Sansui A909 Amp and BOSE Acoustimass speakers for the audio.
- My Location
- Staffs UK
It holds the motor assembly to the worm drive shaft..
scopus
Specialist Contributor
- My Satellite Setup
- Primesat/Famaval 1.8 PF C/ku/Ka, Octagon SX8HD1, SX88, Openbox S3 Mini HD-V8S Freesat V7 HD-V8 Finder, Amiko A4K Combo, Satlook Colour HD Spectrum, Sansui A909 Amp and BOSE Acoustimass speakers for the audio.
- My Location
- Staffs UK
Sorry Nelson, didn't realise you had answered..
- My Satellite Setup
- A little less analogue, and a lot more crap.
- My Location
- UK
There will be a hole in the shaft end (ooooerrr) into which it locates.