Advice Needed CM 1.2M parts enquiry

Markjose

Markjose

Young one with a hobby
My Satellite Setup
Triax 110 ..... No fixed location
My Location
Monmouth
Hello All,

I have picked up a CM 1.2 on a well known auction site however I missing am missing bolts to attach the dish to the pole mount. Anyone know where I could get them ? Or have ideas of measurements?

Could also do with some new u bolts but not urgent.

Thanks

Mark
 
That was easy and will just measure the u bolts when I have a sec
 
On the back of this does anyone know the u bolts size for the tm2300 ?

Thanks
 
Could you post a picture of the mount you have?
 
Will do later finally got inspect my purchase and noticed the dish mount looks to be not original thoughts
 

Attachments

  • PXL_20240510_061209138.jpg
    PXL_20240510_061209138.jpg
    2.4 MB · Views: 26
That was why my question, as original CM mount has no U-bolts. In this case, you can measure an old U-bolt and purchase the same one. Do you have an idea what kind of pole will you use to hang your CM120?
 
I have a few scaffolding poles concreted in the garden so probs one of them, I'm more concerned about the lack of measurements on the dish brackets, however I guess I could just work out by getting the strongest signal.

This dish will be at ground level and not attached to a house for sure.
 
No DiSEqC motor based on the Taiwanese designs had U bolts as a clamp, they would be four sides of a hexagon with a toothed plate closed by two 13mm nuts.
 
Got it now im back home will need to measure and get back to you.
 
Back
Top