ConEmu - hash ok and then it starts over

S

slopface

Member
Messages
2
Likes
0
#1
Hi Folks,

Could any1 of you experts please help my out of this deep frustration.

I have my ConEmu running on a 486DX/2 50 and everything looks beautiful until it actually have to decode the screen.

Signature correct and the hash ok, but then it starts over again with the send ATR etc.

What wrong ????? :confused :confused :confused :confused

Thanks in advance,

/Slopface
 
Burnt Chips

Burnt Chips

Overclocker Supreme & General Mad B*st*rd
Messages
453
Likes
0
My Location
sunny manchester (i wish )
#2
I AINT NO EXPERT so that rules me out, but if your sending ATR,
then you should get a page of recieved codes, (alt f2) its here where your errors codes occur, you aint stated what Cam your useing
or wether (boot disk or windows version) or possibly have you updated with febuary codes (28-01-03) released.
 
S

slopface

Member
Messages
2
Likes
0
#3
Originally posted by Burnt Chips
I AINT NO EXPERT so that rules me out, but if your sending ATR,
then you should get a page of recieved codes, (alt f2) its here where your errors codes occur, you aint stated what Cam your useing
or wether (boot disk or windows version) or possibly have you updated with febuary codes (28-01-03) released.
I'm using the embedded cam in a Force 1122.

I'm using the Linux version WITH the new keys.

It works on my celeron machine, but not on the good oldie :-ohmy(

As stated above I get the signature correct, and the hash OK !!!!

I'm desperate to get the good oldie to work....

Thanks in advance,

Slopface
 
Burnt Chips

Burnt Chips

Overclocker Supreme & General Mad B*st*rd
Messages
453
Likes
0
My Location
sunny manchester (i wish )
#4
its gotta b baud rate then, those old pc`s probally have a lot slower baud-rate (comunication speed) id try 7200 or even lower
 
Top