adoniram
Member
- Joined
- Jun 24, 2008
- Messages
- 7
- Reaction score
- 0
- Points
- 0
- Age
- 61
- My Satellite Setup
- DB 500s
- My Location
- GREECE
Hi from Athens,
I' m trying to wirelessly connect my DB500s with a Tilgin Vood 452w modem-router using an ethernet bridge Linksys WET54G.
I connected the bridge to a PC w/o Internet access and tried to configure it according the included instructions.
After a few attempts, the PC connected to the router.
Then I removed the bridge from the PC, and tried to connect the DB.
NO LUCK !!!!!!!!!!!!!
The Power & Wireless leds are always ON, but Ethernet led NOT.
My WET54G is a v.3.1 running 2.7 US firmware.
Router 192.168.1.1
PC(1) 192.168.1.100 (connected wirelessly via a USB stick)
PC(2) 192.168.1.200 (connected wirelessly via a USB stick)
WET54G 192.168.1.226
DB500s 192.168.1.101 - 255.255.255.0 - 192.168.1.1 - LAN enabled - Port 80 - Nameserver & Gateway (Router IP)
For both configuration & connection I used the included CROSS ethernet cable.
Any help mates?
Thanks in advance
I' m trying to wirelessly connect my DB500s with a Tilgin Vood 452w modem-router using an ethernet bridge Linksys WET54G.
I connected the bridge to a PC w/o Internet access and tried to configure it according the included instructions.
After a few attempts, the PC connected to the router.
Then I removed the bridge from the PC, and tried to connect the DB.
NO LUCK !!!!!!!!!!!!!
The Power & Wireless leds are always ON, but Ethernet led NOT.
My WET54G is a v.3.1 running 2.7 US firmware.
Router 192.168.1.1
PC(1) 192.168.1.100 (connected wirelessly via a USB stick)
PC(2) 192.168.1.200 (connected wirelessly via a USB stick)
WET54G 192.168.1.226
DB500s 192.168.1.101 - 255.255.255.0 - 192.168.1.1 - LAN enabled - Port 80 - Nameserver & Gateway (Router IP)
For both configuration & connection I used the included CROSS ethernet cable.
Any help mates?
Thanks in advance