disappointment

A

ads7112

Member
Messages
2
Likes
0
#1
I am posting here because I would like than no other people does my same mistake

There is not a lot to say
only that the DRAGON CAM has been very disapponting
May be the cam from the hardware point of view could be fine
but hardware without proper firmware is completely useless
as the cam now
Being the use of this cam based on firmware update, and being the support provided VERY BAD, the quality and the value of this cam is actually very low
I advice whoever read this tread to be far from the DRAGON CAM and from any other product provided by the same company (DREAM MULTIMEDIA)
 
rolfw

rolfw

Believe it when I see it Admin.
Staff member
Messages
37,726
Likes
1,291
My Satellite Setup
Technomate 5402 HD M2 Ci, DM7000s, Transparent 80cm Dish, Moteck SG2100 DiseqC motor, lots of legacy gear. Meters: Satlook Digital NIT, Promax HD Ranger+ spectrum analyser.
My Location
Berkshire
#2
Yes, as you say, the support does leave something to be desired, but bear in mind that the channels are disappearing everywhere, including for those using Titanium, MR and X-CAM.
 
Top